Microstructure and tribological properties of laser clad γ/Cr₇C₃/TiC composite coatings on γ-TiAl intermetallic alloy

In order to improve the wear resistance of the γ-TiAl intermetallic alloy, microstructure, room- and high-temperature (600 °C) wear behaviors of laser clad γ/Cr₇C₃/TiC composite coatings with different constitution of NiCr-Cr₃C₂ precursor-mixed powders have been investigated by optical microscopy (OM), scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive spectrometer (EDS), block-on-ring (room-temperature) and pin-on-disk (high-temperature) wear tests. The responding wear mechanisms are discussed in detail. Results show that microstructures of the laser clad composite coatings have non-equilibrium solidified microstructures consisting of primary hard Cr₇C₃ and TiC carbides and the inter-primary γ/Cr₇C₃ eutectic matrix, about three to five times higher average microhardness compared with the TiAl alloy substrate. Higher wear resistance than the original TiAl alloy is achieved in the clad composite coatings under dry sliding wear conditions, which is closely related to the formation of non-equilibrium solidified reinforced Cr₇C₃ and TiC carbides and the positive contribution of the relatively ductile and tough γ/Cr₇C₃ eutectics matrix and their stability under high-temperature exposure.