Microstructure and characteristics of Zn and Mg-doped LiNbO₃ materials for electrochromic devices

In this investigation, polycrystalline targets of lithium niobate (LN), zinc-doped lithium niobate (Zn:LN), and magnesium-doped lithium niobate (Mg:LN) were synthesized utilizing the Hot Isostatic Pressing (HIP) and Cold Isostatic Pressing (CIP) sintering technique. Subsequently, amorphous thin films of LN, Zn:LN, and Mg:LN and electrochromic devices were fabricated via radio frequency (RF) magnetron sputtering. Comprehensive characterization of the microstructure and optoelectronic properties of the targets, films and devices was conducted employing scanning electron microscopy, X-ray diffraction, spectrophotometry, atomic force microscopy, and an electrochemical workstation. Studies have shown that doping with zinc and magnesium enhances the sintering quality of ceramics, reducing lithium vacancies in polycrystalline lithium niobate ceramics. Zinc doping increases the resistance of lithium niobate, whereas magnesium doping introduces a secondary phase that decreases the resistance. The resistances of LN, Zn:LN, and Mg:LN polycrystalline ceramics are 8.35 GΩ, 9.80 GΩ, and 7.61 GΩ, respectively. The doping process refines the growth of the target and film particles, enhancing the microstructural quality. Notably, the ionic conductivity of the Mg:LN film escalates to 1.7 × 10⁻⁵ S/cm. Using doped lithium niobate thin films as electrolytes, the electrochromic devices showed a 38 % increase in coloration efficiency and a 46 % improvement in bleaching efficiency, significantly enhancing device performance.