Influence of main swirler vane angle on the ignition performance of Teless-II combustor

In order to balance the low emission and wide stabilization for lean premixed prevaporized combustion, the centrally staged layout is preferred in advanced aero-engine combustors. However, compared with the conventional combustor, it is more difficult for the centrally staged combustor to light up as the main stage air layer will prevent the pilot fuel droplets arriving at igniter tip. The goal of the present paper is to study the effect of the main stage air on the ignition of the centrally staged combustor. Two cases of the main swirler vane angle of the TeLESS-II combustor, 20° and 30° are researched. The ignition results at room inlet temperature and pressure show that the ignition performance of the 30° vane angle case is better than that of the 20° vane angle case. High speed camera, PLIF and CFD are used to better understand the ignition results. The high-speed camera has recorded the ignition process, indicated that an initial kernel forms just adjacent the liner wall after the igniter is turned on, the kernel propagates along the radial direction to the combustor center and begins to grow into a big flame, and then it spreads to the exit of the pilot stage, and eventually stabilizes the flame. CFD of the cold flow field coupled with spray field is conducted. A verification of the CFD method has been applied with PLIF measurement, and the simulation results can qualitatively represent the experimental data in terms of fuel distribution. The CFD results show that the radial dimensions of the primary recirculation zone of the two cases are very similar, and the dominant cause of the different ignition results is the vapor distribution of the fuel. The concentration of kerosene vapor of the 30° vane angle case is much larger than that of the 20° vane angle case close to the igniter tip and along the propagation route of the kernel, therefore, the 30° vane angle case has a better ignition performance. For the consideration of the ignition performance, a larger main swirler vane angle of 30° is suggested for the better fuel distribution when designing a centrally staged combustor.