Design and fabrication of stereolithography-based aeroelastic wing models

Purpose - The purpose of this paper is to present a novel method to design and fabricate aeroelastic wing models for wind tunnel tests based on stereolithography (SL). This method can ensure the structural similarity of both external and internal structures between models and prototypes. Design/methodology/approach - An aluminum wing-box was selected as the prototype, and its natural modes were studied by FEA and scaled down to obtain the desired dynamic behavior data. According to similarity laws, the structurally similar model was designed through a sequential design procedure of dimensional scaling, stiffness optimization and mass optimization. An SL model was then fabricated, and its actual natural modes was tested and compared with the desired data of the prototype. Findings - The first two natural frequencies of the model presented strong correlation with the desired data of the prototype. Both the external and internal structures of the model matched the prototype closely. The SL-based method can significantly reduce the total mass and simplify the locating operations of balance-weights. The cost and time for the fabrication were reduced significantly. Research limitations/implications - Further investigation into the material properties of SL resins including stiffness and damping behaviors due to layered process is recommended toward higher prediction accuracy. Wind tunnel tests are needed to study the ITin situ/IT performance and durability of SL models. Originality/value - Although the paper takes a wing-box as the study object, structurally similar SL models of entire wings can be obtained conveniently, benefiting from the low-stiffness material properties of SL resins and the fabrication capacity to build complex structures of SL process. This paper enhances the versatility of using SL and other rapid prototyping processes to fabricate models to predict aeroelastic characteristics of aircraft.